Description

Copper Terminals Negative and Positive Clamps Connectors(2pairs),AWG Wire Cable Lugs Ring Terminals,Anti-Corrosion Washers and Heat Shrink Tube Assortment Kit Description: 1. Product material: brass 2. Product attributes: red positive electrode, black negative electrode 3. Product function: connect the battery and battery cable, power on the equipment, etc. 4. Scope of application: General Motors, batteries, etc. 5. Product advantages: Copper is better than aluminum alloy, because aluminum alloy has weak contact points and strong corrosiveness, and is better than zinc alloy, because zinc alloy is highly corrosive, brass is preferred, and the product is equipped with protective sleeves. 6. Anode aperture: 17-19MM 7. Aperture of negative electrode: 15-17MM 8. Matters needing attention: Please make sure that the battery is powered off before installation. 8. Product portfolio: Red positive chuck-2pcs, black negative chuck-2pcs Terminal 4*5/16-2pcs 、 2*5/16-2PCS, 1/0*5/16-2pcs Battery protection pad positive -2pcs Battery protection pad negative-2pcs Heat shrinkable tube red Φ14-3pcs Heat shrinkable tube black Φ14-3pcs Heat shrink tube red Φ16-3pcs Heat shrinkable tube black Φ16-3pcs Installation Notes: Step 1: Remove the positive and negative pole clamps of the original car from the battery pile, and separate them from the battery harness (note: the general positive pole is thicker than the negative pole: conventional positive 13-15MM, negative 11-13MM); Step 2: Connect the wiring harness to the new battery chuck, and lock it with the screw on the connector (note: if the original terminal is aging, you can replace it with a new terminal); Step 3: Install the positive stage first, put the new battery chuck on the battery pole, and adjust the tightness with screws. The installation method of the negative chuck is the same as above. The package includes: 1 Set eBay Cross Border Trade powered by ChannelEffect